adm8211 v20041111 driver by "FlamingICE" for ADMtek wireless devices
for Puppy Linux with kernel 2.4.29 - versions 1.0.4 and 1.0.5
from http://aluminum.sourmilk.net/adm8211/
compiled by tempestuous, September 2005.
Not tested.
No guarantees.  No support.

This Linux wireless driver package supports ADMtek ADM8211A/B/C chipsets, in PCI and cardbus devices.
It was further developed from ADMtek's original Linux driver by "FlamingICE" (Michael Wu).


INSTRUCTIONS
## uncompress the driver package from the uppermost directory
cd /
tar -zxvf adm8211.tar.gz
## map the new module
depmod

## load the driver
modprobe adm8211
## if no error messages, this should create a network interface, eth0
## can check this by running ifconfig -a
## now set up the wireless network
iwconfig eth0 essid MY_ESSID key 1234567890 mode Managed
## for automatic IP
dhcpcd -t 20 -h puppypc -d eth0
## or for static IP
## modify /etc/resolv.conf to include your nameservers
#ifconfig eth0 192.168.0.xx broadcast 192.168.0.255 netmask 255.255.255.0
#route add default gw 192.168.0.1 eth0   # or whatever your router's IP is


MAKING IT PERMANENT
If this driver works with your hardware, you will want to have it available every time you boot up.
Save the driver tarball to your /root directory, which is persistent if you use a pupfile.
Add the uncompress and depmod commands to /root/.etc/rc.d/rc.local

cd /
tar -zxvf /root/adm8211.tar.gz
depmod

This will install the driver every time you boot up, ready to load and configure as explained above.
A script for this purpose, "adm8211-connect" is available.  Just modify the script to include your wireless settings.